NIOSH N95 Industrial Respirator

N95 Particulate Respirator

BM-A105-25
BM-A105-10

• 100% Made in the USA in Indiana by FSSC LLC.
• NIOSH Certified N95 Respirator, Title 42, Code of Federal Regulations, Part 84 (42 CFR 84).
• One size fits all. Features elastic head and neck straps to help maintain maximum facial fit and seal.
  Size of Facial Cup: 5.75″ side-to-side, 6.125″ top-to-bottom, 4.25″ front edge to side.
• High breathability. Users report having ample room in front of their mouth and nose to breath while wearing.
• High efficiency rating. Our N95 respirators meet NIOSH filtration requirements, filtering at least 95% of non-oil based airborne particles. (42 CFR 84), [Approval Number: 84A-9272])
• Adjustable nose clip. For use with and without glasses due to the adjustable metal nose clip.
• Available in 25 count single use pack (BM-A105-25) or 10 count single use pack (BM-A105-10).

Use Instructions

• Respirator may be used until damaged, breathing becomes difficult, or contaminated with blood or body fluids.
• It is recommended to use the respirator for an extended period rather than reusing. If reusing the respirator, ensure you inspect for damage, contamination from blood or body fluids, and consult with your organizations policies on reusing respirators. It is not recommended to reuse the respirator.
• Filtering facepieces are to be inspected prior to each use to assure there are no holes in the breathing zone. Enlarged holes resulting from ripped or torn filter material is considered damage. Immediately replace respirator if damaged.

1. Cup the mask into your hand with the nosepiece right-side up and the headbands hanging down
2. Position the respirator under your chin and the nosepiece on the bridge of your nose
3. While holding the respirator in position, pull the top headband over your head and rest it at the crown of the back of your head
4. As you continue to hold the bottom headband over your head and rest it around your upper neck, below your ears
5. Untwist the straps and optimally position the respirator low on your nose
6. Using both hands, mold the nosepiece to fix snugly against the nose bridge and face, below the eyes
7. Using a mirror, further check and adjust the edges to provide a good seal around the face
8. Perform a user seal check prior to each wearing. To check the respirator-to-face seal, cover the mask with one or both hands, Inhale and exhale sharply. Be careful not to disturb the position of the respirator. If air leaks around the nose, re-adjust the nosepiece as described in step 6. If air leaks around respirator edges, adjust panels and straps. If you CANNOT achieve a proper fit, DO NOT enter the contaminated area. See your supervisor.

Material Composition

• Outer Layer: Polypropylene spunbond
• Filter: Melt-blown non-woven electro-statically charged 3 layers
• Inner Layer: Polypropylene spunbond
• Nose Clip: Polyethylene coated double wire
• Head Strap: Elastic spandex